RuggedCom RSG2488 User Manual

Chapter 5
Setup and Configuration
RUGGEDCOM RSG2488
User Guide
174 Configuring LLDP for an Ethernet Port
Parameter Description
Tx Delay Synopsis: 1 to 8192 s
Default: 2 s
The delay in seconds between successive LLDP frame transmissions initiated by value
or status changed. The recommended value is set by the following formula:
1 <= txDelay <= (0.25 * Tx Interval)
3. Click Apply.
Section 5.7.2
Configuring LLDP for an Ethernet Port
To configure LLDP for a specific Ethernet Port, do the following:
1. Navigate to Network Discovery > Link Layer Discovery Protocol > Configure Port LLDP Parameters. The
Port LLDP Parameters table appears.
Figure 135: Port LLDP Parameters Table
2. Select a port. The Port LLDP Parameters form appears.
54
3
2
1
Figure 136: Port LLDP Parameters Form
1. State Options 2. Port Box 3. Admin Status List 4. Notifications Options 5. Apply Button 6. Reload Button
3. Configure the following parameter(s) as required:
Parameter Description
State Synopsis: { Disabled, Enabled }
Default: Enabled

RuggedCom RSG2488 Specifications

General

Brand	RuggedCom
Model	RSG2488
Category	Switch
Language	English