RuggedCom RSG2488

Chapter 5
Setup and Configuration
RUGGEDCOM RSG2488
User Guide
116 Configuring VLANs for Ethernet Ports
Figure 76: VLAN Summary Table
If a VLANs are not listed, add static VLANs as needed. For more information, refer to Section 5.1.4.2, “Adding a
Static VLAN”.
Section 5.1.3
Configuring VLANs for Ethernet Ports
When a VLAN ID is assigned to an Ethernet port, the VLAN appears in the VLAN Summary table where it can be
further configured.
To configure a VLAN for an Ethernet port, do the following:
1. Navigate to Virtual LANs > Configure Port VLAN Parameters. The Port VLAN Parameters table appears.
Figure 77: Port VLAN Parameters Table
2. Select a port. The Port VLAN Parameters form appears.
65
4
3
2
1
Figure 78: Port VLAN Parameters Form
1. Port(s) Box 2. Type List 3. PVID Box 4. PVID Form Options 5. Apply Button 6. Reload Button
3. Configure the following parameter(s) as required: