RuggedCom RSG2488 User Manual

Chapter 5
Setup and Configuration
RUGGEDCOM RSG2488
User Guide
164 Adding an SNMP User
Section 5.6.1.2
Adding an SNMP User
Multiple users (up to a maximum of 32) can be configured for the local SNMPv3 engine, as well as SNMPv1 and
SNMPv2c communities.
NOTE
When employing the SNMPv1 or SNMPv2c security level, the User Name parameter maps the
community name with the security group and access level.
To add a new SNMP user, do the following:
1. Navigate to Administration > Configure SNMP > Configure SNMP Users. The SNMP Users table appears.
1
Figure 120: SNMP Users Table
1. InsertRecord
2. Click InsertRecord. The SNMP Users form appears.
12
10
11
9
8
7
6
5
4
3
2
1
Figure 121: SNMP Users Form
1. Name Box 2. IP Address Box 3. v1/v2c Community Box 4. Auth Protocol Box 5. Priv Protocol Box 6. Auth Key Box
7. Confirm Auth Key Box 8. Priv Key Box 9. Confirm Priv Key Box 10. Apply Button 11. Delete Button 12. Reload Button

RuggedCom RSG2488 Specifications

General

Brand	RuggedCom
Model	RSG2488
Category	Switch
Language	English