RUGGEDCOM RSG2488
User Guide
Chapter 3
Device Management
Managing RMON Events 87
Section 3.11.3
Managing RMON Events
Remote Monitoring (RMON) events define behavior profiles used in event logging. These profiles are used by
RMON alarms to send traps and log events.
Each alarm may specify that a log entry be created on its behalf whenever the event occurs. Each entry may
also specify that a notification should occur by way of SNMP trap messages. In this case, the user for the trap
message is specified as the Community.
Two traps are defined: risingAlarm and fallingAlarm.
The following sections describe how to configure and manage RMON events:
• Section 3.11.3.1, “Viewing a List of RMON Events”
• Section 3.11.3.2, “Adding an RMON Event”
• Section 3.11.3.3, “Deleting an RMON Event”
Section 3.11.3.1
Viewing a List of RMON Events
To view a list of RMON events, navigate to Ethernet Stats > Configure RMON Events. The RMON Events table
appears.
Figure 55: RMON Events Table
If events have not been configured, add events as needed. For more information, refer to Section 3.11.3.2,
“Adding an RMON Event”.
Section 3.11.3.2
Adding an RMON Event
To add an RMON alarm, do the following:
1. Navigate to Ethernet Stats > Configure RMON Events. The RMON Events table appears.
To Next Page
Loading...
Need help?
General
