RuggedCom RSG2488 User Manual

Chapter 3
Device Management
RUGGEDCOM RSG2488
User Guide
56 Viewing a List of Remote Syslog Servers
Parameter Description
The local UDP port through which the client sends information to the server(s).
3. Click Apply.
Section 3.6.4.2
Viewing a List of Remote Syslog Servers
To view a list of known remote syslog servers, navigate to Administration > Configure Syslog > Configure Remote
Syslog Server. The Remote Syslog Server table appears.
Figure 16: Remote Syslog Server Table
If remote syslog servers have not been configured, add the servers as needed. For more information, refer to
Section 3.6.4.3, “Adding a Remote Syslog Server”.
Section 3.6.4.3
Adding a Remote Syslog Server
ROS supports up to 5 remote syslog servers (or collectors). Similar to the local system log, a remote system log
server can be configured to log information at a specific severity level. Only messages of a severity level equal to
or greater than the specified severity level are written to the log.
To add a remote syslog server to the list of known servers, do the following:
1. Navigate to Administration > Configure Syslog > Configure Remote Syslog Server. The Remote Syslog
Server table appears.
1
Figure 17: Remote Syslog Server Table
1. InsertRecord

RuggedCom RSG2488 Specifications

General

Brand	RuggedCom
Model	RSG2488
Category	Switch
Language	English