RuggedCom RSG2488 User Manual

Chapter 3
Device Management
RUGGEDCOM RSG2488
User Guide
74 Deleting a Switch IP Interface
Parameter Description
Specifies the IP subnet mask of this device. An IP subnet mask is a 32-bit number that
is notated by using four numbers from 0 through 255, separated by periods. Typically,
subnet mask numbers use either 0 or 255 as values (e.g. 255.255.255.0) but other
numbers can appear.
4. Click Apply.
Section 3.8.2.3
Deleting a Switch IP Interface
To delete a switch IP interface configured on the device, do the following:
1. Navigate to Administration > Configure IP Interfaces > Configure Switch IP Interfaces. The Switch IP
Interfaces table appears.
Figure 36: Switch IP Interfaces Table
2. Select the IP interface from the table. The Switch IP Interfaces form appears.
1
Figure 37: Switch IP Interfaces Form
1. IP Address Type Box 2. IP Address Box 3. Subnet Box 4. Apply Button 5. Delete Button 6. Reload Button
3. Click Delete.
Section 3.9
Managing IP Gateways
ROS allows up to ten IP gateways to be configured. When both the Destination and Subnet parameters are
blank, the gateway is considered to be a default gateway.

RuggedCom RSG2488 Specifications

General

Brand	RuggedCom
Model	RSG2488
Category	Switch
Language	English