RuggedCom RSG2488 User Manual

RUGGEDCOM RSG2488
User Guide
Chapter 2
Using ROS
Connecting to ROS 25
Using ROS
This chapter describes how to use the ROS interface. It describes the following tasks:
• Section 2.1, “Connecting to ROS”
• Section 2.2, “Logging In”
• Section 2.3, “Logging Out”
• Section 2.4, “Using the Web Interface”
• Section 2.5, “Using the Console Interface”
• Section 2.6, “Using the Command Line Interface”
• Section 2.7, “Managing the Flash File System”
• Section 2.8, “Accessing BIST Mode”
• Section 2.9, “Accessing the Boot Loader”
Section 2.1
Connecting to ROS
The following describes the various methods for connecting the device:
• Section 2.1.1, “Connecting to ROS Through a Direct Connection”
• Section 2.1.2, “Connecting to ROS Through the Network”
Section 2.1.1
Connecting to ROS Through a Direct Connection
ROS can be accessed through a direct serial or Ethernet connection.
Using the RS232 Serial Console Port
To establish a serial connection to the device, do the following:
1. Connect a terminal or a computer running terminal emulation software to the RS232 serial console port on
the device. For more information about the RS232 serial console port, refer to the RSG2488 Installation
Guide.
NOTE
The baud rate for the device is printed on the chassis exterior near the RS232 serial console port.
2. Make sure the following settings are configured on the terminal:
• Speed (baud): 57600

RuggedCom RSG2488 Specifications

General

Brand	RuggedCom
Model	RSG2488
Category	Switch
Language	English