Sam4POS Operators Manual v2.33 Appendix • 259
Performing EFT Operations
When performing EFT Operations, the EFT Operation communication between the ECR and the Tran device is
displayed on the Sam4POS. When the specified operation is completed, the register will print the results of the
requested operation at the register’s receipt printer. You can also print out the EFT Operation communication to the
register receipt if desired.
Initialize EFT
Select Initialize EFT to verify communications, software versions and installed networks.
1. From the main PROGRAM MODE menu screen, select DEVICE, then touch EFT OPERATION.
2. Select Datacap_Operation from the selections.
3. Select INITIALIZE EFT. The register will display “Information Working”
4. The “List Of Installed Networks” prints and the EFT OPERATION dialog is displayed:
5. You can PRINT the response if desired; then press CLOSE.
Sample Initialize EFT chit:
SAM4POS TERMINAL
2017-09-27 11:26 WED
**** LIST INSTALLED NETWORKS ****
EMC --- --- --- Ver: 3.95 SL
ON OFF OFF OFF
- - - - - - - - - - - - - - - - - - - -
NO. 000005 REG# POS-1 MANAGER
List of Installed Networks
Status of Installed Networks
Software Version
To Next Page
Loading...
