Sam4s SAP-6600 - Initial Clear;Re-Boot; Initial Clear; Reboot

36 • Getting Started Sam4POS Operators Manual v2.33
Initial Clear/Re-boot
The initial clear procedure allows you to exit any register activity and return to a beginning or cleared state. Any
transaction that is in progress will be exited and totals for that transaction will not be updated.
Initial Clear
The initial clear function allows you to exit any register activity and return to a beginning or cleared state. No
program data is lost by performing this operation.
1. Tap the Version information, in the lower right corner, three times to initial clear the SAM4POS terminal.
2. The Notification dialog below is displayed:
3. Press YES to proceed with the initial clear; or press NO to exit without the initial clear.
4. Sign on to the Sam4POS as normally.
Reboot
1. To Reboot the SAP-6600/4800 Sam4POS, use the main power button on the lower right bottom of display
to power OFF the Sam4POS terminal. (Right side rear, on the SAP-630/530.)
2. Press the confirmation ‘Power off’ dialog to continue.
3. When the Sam4POS is completely shut down, press the power button again to power on the Sam4POS
terminal.
4. The Sam4POS will reboot to the main sign on screen.
Note: If you reboot while a transaction is in progress, the transaction will be aborted, and
totals/counters will not be updated.