Sam4POS Operators Manual v2.33 Basic Operations • 49
Clocking In/Out
The Sam4POS provides a basic time-keeping system for daily reporting and weekly payroll. Additional
programming is required to utilize this feature.
Employees can clock-in from the register mode using the Time In/Out key or Clock in can be performed from the
Main Sign on screen.
Note: Depending upon the authority level programming, the employee will sign on with their employee clock in code
which may be different than the employee operating code. Employees could also be set to clock-in using the MCR in
the authority level programming.
Clock In
– Register Mode Time In/Out
1. From the Register Mode screen; Enter the employee clock in CODE and touch the TIME IN/OUT
function key to display the clock in/out window:
Job codes that are available for
the employee are displayed.
2. Touch the JOB CODE selection for the job you are performing to clock in.
3. The clock-in time and Job code selected displays.
4. Touch OK to complete the clock in.
To Next Page
Loading...
