SatLab SLT2 - Page 158

Total Station Manual
-
157
-
○
2
There appears a dialog as
shown in the picture on the right.
If want to back to the previous
menu, you can press [F1] (Back).
○
3
Input the new name and
coordinate of fixpoint, press [Ent]
to finish inputting and press [F4]
(OK) to save the fixpoint.
If the inputted point name exists in
the memory, the program will give
a prompt of whether to overwrite,
press [F4](Yes) to overwrite or
press [F1](No) to cancel the
operation.
[F4]
○
4 After finishing new a fixpoint,
the program makes the point plus
1 automatically and you can
continue to input other fix points,
as shown in the picture on the
right. Press [F1] (Back) or [ESC] to
go back.