Total Station Manual
○
4
Move the prism just standing
below the remote point, then
aim at the bottom of prism rod
and press [F1] (ALL) or [F2] + [F3]
(DIST + REC) to finish the base
point measuring.
○
5 Turn the instrument
telescope aimed at prism and
press [F4] to measure the prism
high. Then enter the [REM PT]
window.
○
6
Turn the instrument
telescope aimed at remote point
and press [F4] to finish current
remote point measuring. Press
[F1] to re-set the base point.
COGO(Coordinate Geometry)is an application used to perform coordinate
geometry calculations by the preset conditions such as , coordinates of points,
bearings between points and distance between points.
The COGO calculation methods include:
Use the traverse sub application to calculate the plane coordinate of a new
point using the bearing and distance from a known point. Offset is optional.
To Next Page
Loading...