SatLab SLT2 - Area & Volume

Total Station Manual
-
98
-
9. Area & Volume
Area is an application used to calculate the polygon areas to a maximum of 20
points which connected by straights. The target points coordinate can be measured,
selected from memory or entered via keypad in same direction. And the following
three methods can be alternately performed. The calculate area is projected onto the
horizontal plane (2D).
Figure 9.1 Area Diagram
P0 Instrument Point
P1 Start Target Point
P1~P5 Target Point
a Perimeter, polygonal length from start point to the current measure
point.
S Calculated area always closed to the start point P1, projected onto
the horizontal plane.
Select “Program” from the [Main Menu] window, then press [PAGE] switch to
second program list and press [F1] or number key [5] to enter the Area application.
Steps
Key
Display
○
1 Select “Program” from the
[Main Menu] window, then press
[PAGE] switch to second program
list and press [F1] or number key
[5] to enter the Area/volume app.
[PAGE]
+
[F1]
or
[5]