SatLab SLT2 - Hidden Point Measurement

Total Station Manual
-
50
-
○
4 After finishing setting up
the fixpoint, the height of
fixpoint is displayed in the
screen and press [F1](ALL)or
[F2](DIST)+[F3](REC) to start to
measure and calculate, the
height of station is calculated.
[F1]
or
[F2]
+
[F3]
○
5
In the interface of [Height
Transfer Result], pressing
[PAGE] to switch the display of
result information.
Press [F1](Add PT) to add a
new point and to start a new
measurement.
Press [F3](Back) to back to
measure the current point
again.
Press [F4](OK)to enter the
interface of [Set STA HO].
[PAGE]
○
6
Pressing [F1] to back to the
interface of [Height Transfer
Result].
Press [F2] to set the height of
station to the old value
Press [F4] to set the height of
station to the new value which
calculated after Height Transfer.
Press [F3] to set the height of
station to the average of the
old value and new value
5. Hidden Point
The function of Hidden Point is using a special hidden point measuring rod to
measure the points which are not intervisible.