SatLab SLT2 - Code

Total Station Manual
-
39
-
3.4 Code
The code contains the information about the recording points, in the process of
post-processing, with the help of encoding function , you can process conveniently
according to the specific group. The function of “File Manager” also contains
the information of code.
Simple Operation of Code
1. Move the cursor to the line of Code.
2. Enter the name of Code.
3. Press the key of [ALL] to start the distance measurement and record the data of
code and measurement at the same time. If the name of code already exists in
the code library, it will extract the information of code in the code library to
record at the same time.
Steps
Key
Display
○
1
Move the cursor to the line of
Code.
↓
○
2
Enter code and press [ENT] to
make sure. The entered code
here will not be added to the
code library.
Input code
+
[ENT]
○
3 Press [F1] to start to measure,
record the code and the date of
measurement to job at the same
time.
※
1