Total Station Manual
Delete the selected fixpoint from the job.
○
1 In the interface of View
FixPoint, you can find the data of
need to be deleted by pressing
the direction key of left or right
or in the function of finding, then
press [F4] to switch to the second
page of soft key.
If you want to change the job
which the point needs to be
deleted, you can press [Job] to
select the target job.
○
2 Press [F1] (Delete) to start the
function of deleting data, the
interface as shown the dialog on
the right. Press [F4] (OK) to
delete data and press [F1] (No)
to cancel the operation.
○
3 The interface backs to the
previous menu.
The measurement data in the job can be searched, displayed, and part of them
can be deleted.
To Next Page
Loading...