SatLab SLT2 - Station Setup Procedures

Total Station Manual
-
59
-
2. Setting the Station
Every target coordinate's calculation is related to the position of the station. The
station coordinate can be input manually or selected from the instrument memory.
2.1 Select the coordinate from memory [Find]
Steps:
1、 Select the coordinate from memory.
2、 Input instrument height.
3、 [OK] Set station.
Steps
Key
Display
○
1 Press [F2] in the Pre-Settings
screen. Then enter the Set STA
function.
[F2]
○
2
Input the name of the station
point which exists in the job and
then press [ENT]. ※
1
Input point
name
+
[ENT]