○
3 Press [F1](Find):
A: If the input name exists in the
current job, there will show the
screens shown on the right
figure. The multiple points with
the same name will be sorted by
type.
B: If the input name doesn’t exist
in the current job, the program
prompts the message “Pt. not
found”. Then enter the [Find Pt.]
screen.
There can also select point from
other jobs and set it as the
station point. Input the point
name and press [F4](Find). If the
point is found, press [OK] in the
[Find Pt.] list screen to set it as
station. Program enter input
instrument height screen. If the
point doesn’t exist, press
[F3](Coord.) to input the
coordinates of N, E and Z. Set this
point as station.
[Zero]: Set this point’s all
coordinates as 0 and set the
point as station.
[Coord.]: Enter [Input Coord.]
screen. Input the coordinates and
save them to the current job.
○
4
Enter input instrument height
screen. Input the instrument
height and press [ENT] to
confirm. Then press [F4](OK) to
save and set the station
information.
Press [ESC] then back to previous
To Next Page
Loading...