SatLab SLT2 - EDM Settings Configuration; EDM Measurement Modes

Total Station Manual
-
26
-
2. EDM Setting
2.1 Set the mode of EDM
Select the mode of distance measurement, there are 6 modes :
Single,Repeat,Tracking,3 Times,4 Times,5 Times.
Steps
Key
Display
○
1 Press [F4]( ↓ )and show the
second soft key in the
Q-Surveying. Press [F3] to enter
the interface of EDM Setting.
[F4]
[F3]
○
2
When the cursor is in EDM
mode option, Press the direction
key of←→ to select the mode of
measurement. Each time you
press ← or → , the mode of
measurement is switched.
←
→
○
3 After finishing setting, press
[F3](OK) to return the function of
Q-Surveying. If you want to
cancel the settings, press [ESC] to
ignore the changes.
[F3]
Set the reflector type
Our series total station can be set up for the red laser (RL) range and invisible
infrared light (IR) range and the total station has three reflectors to be selected,
which are prism, non-prism (NP) and reflect board (Sheet). You can set by job,but the
prism used should be matched with prism constants.
 About the parameters of various reflectors in distance measurement, please