SatLab SLT2 - Input the Coordinates Manually

Total Station Manual
-
62
-
○
4 Select the needed point
through Up and Down key.
[View]: Show the information of
this point.
[Coord.]: Input the coordinate
data manually.
[Job]: Select data from another
job.
↑
↓
[View]:
[Coord.]:
[Job]:
○
5
After selecting needed point,
press [F4](OK) and enter input
instrument height screen.
Complete all settings and then
back to Pre-Settings screen.
[F4]
input
instrument
height
+
[ENT]
[F4]
2.3 Input the coordinates manually.
Steps:
1. Press [Coord.], enter input coordinate screen.
2. Input the point name and coordinates.