SatLab SLT2 - Orthogonal Stakeout Mode

Total Station Manual
-
80
-
6.3 Orthogonal to Station Stakeout Mode
Use longitudinal difference and perpendicular difference to indicate the position
differences of stakeout point and current prism position.
The meanings of the differences in the Orthogonal to Station Stakeout Mode:
△Length Difference in longitudinal distance: If the measured point is farther
than stakeout point, the value is positive.
△Trav. Difference in perpendicular distance: If the measured point is located
in the right side of stakeout point, the value is positive.
Steps
Key
Display
○
1
Press [PAGE] to show
Orthogonal to Station Stakeout
Mode in page 2/3. Set the
stakeout point. The stakeout
point can be found in the job
through inputting point name in
the search item.
[PAGE]
○
2 Press direction key and move
the cursor to input prism height
item. Input the prism height and
then press [ENT] to confirm.
↓
+
Input prism
height
+
[ENT]