Total Station Manual
Road is an application used to measure or stake out points relative to a defined
element. The element can be a line, curve or spiral. Chainage, incremental stake outs
and offsets(left and right) are supported.
Setting job, setting station and setting backsight must be done before road
define and staking out.
After setting up the job, station and back sight point, user can start to define the
road path.
○
1
Pressing key [F4] to start the
road function after job setting,
station setting and BS.
○
2 Pressing key [F1] Define
road path.
To Next Page
Loading...