SatLab SLT2 - System Information and Settings; View System Information; Set System Date and Time

Total Station Manual
-
184
-
○
3
Program will show the
result value, press [F4](OK)
to save.
[F4]
Note: If there is no special requirement, the compensator should be turned on
before Index error correction.
1.6 Instrument constant setting
In Tools Menu, choose “1 Adjust”, and then press [F4] to enter “Const. Setting”.
Press [F4](OK) to save after editing the constants.
1.7 Factory setting
In Tools Menu, choose “1 Adjust”, and then press [5] to enter “Factory Setting”.
If you need to reset the instrument parameters to factory state, you can use this
function, press key [F4] (Yes) and then the instrument will auto power off.