SatLab SLT2 - EDM Signal

Total Station Manual
-
32
-
2. The enter range of the average height above sea level: -9999.9999~9999.9999. The
average altitude retained after the decimal point one, the default value is 0.
Steps
Key
Display
○
1 After entering to the interface
of EDM Setting, press the key of
[F4] to enter the second page of
soft key, then press the key of
[F1](Grid) to set the Grid Scale.
[F4]
[F1]
○
2
Interface displays the current
setting. Enter the values of Scale
and Altitude then press the key of
[ENT].Program calculates the Grid
Scale and displays it in the
interface. If you want to set all
enter area to 0,you can set the
key of [F1] (Reset).
[ENT]
○
3
After finished setting, press
[F4](OK) to save settings and back
to previous menu. Then press the
key of [F3](OK) to save the setting
of EDM and back to the function
of measurement.
[F4]
2.4 EDM signal
The function of signal is to display the intensity of signal received by total
station. If the target is hard to be found or can’t see, using the function can achieve
the best sighting accuracy.