SatLab SLT2 - Starting Measurements; Setting Horizontal Angle (HA)

Total Station Manual
-
33
-
Steps
Key
Display
○
1 After entering to the
interface of EDM Setting, press
the key of [F4] to enter the
second page of soft key, then
press the key of [F2](Signal) to
enter the function of Signal
intensity.
[F4]
+
[F2]
○
2
Using the bar chart and value
of number to show the intensity
of signal received by total station
in the screen. As shown in the
picture on the right.
○
3
Press [F1] or [ESC] to back to
the menu of EDM setting.
[F1]
or
[ESC]