SatLab SLT2 - Page 22

Total Station Manual
-
21
-
○
3
If required point not exists in
the job, user can manually
input it by pressing key F2.
by pressing ENT to input
box.
[F2]
○
4
Input point number and N,
E, Z values, by pressing ENT to
move cursor to next input box.
[ENT]
○
5 After all values finishing
input, pressing key F4 to save
the point to the job.
[F4]
[Job]Choose another job’s points.
○
3 If required point not exists in
the job, user can choose
another job’s points.
[F3]
○
4 Entering job list by pressing
key F1, choose the particular job
and press ENT or F4 to commit
choosing.
[F1]
[F4] [ENT]