SatLab SLT2 - Page 70

Total Station Manual
-
69
-
○
2 Input the point name, and
then press [ENT] to move to next
input item to input prism height.
Input point
name
+
[ENT]
○
3 Input the prism height and
then press [ENT] to move the
cursor to next input item. If
needed, input the code.
Input prism
height
+
[ENT]
○
4 Press [F1](ALL) or press
[F2](DIST) and [F3](REC) to start
measuring and record the
measured data. This data
contains angle, distance and
coordinates. Press [PAGE] to
switch the display mode of the
data.
[F1]
or
[F2]+[F3]
○
5
After finishing measuring one
point, the point name automatic
plus one. Press [F1](ALL) or press
[F2](DIST) and [F3](REC) to
continue measuring next point.
At this time, the screen remains
the last measured data which can
be looked over by pressing
[PAGE].