○
3 After inputting the target
point’s name or wildcard (*),
press [ENT] and then press
[F4](View) to look over the data.
If there is no match point, the
program prompts “Pt. not
found!”
[Job]: Select the job where the
measured data is to be viewed.
○
4
Go to View Measured Point
screen. Press [PAGE] to turn the
page and look over all data field
of this point. Press direction key
← and → to browse the last or
next measured point.
[Delete]: Delete this point data.
[Search]: Back to the Find Point
screen.
To Next Page
Loading...