Sea-doo 2005 4-Tec models User Manual

Section 08 STEERING SYSTEM
Subsection 01 (STEERING SYSTEM)
1
2
F18K0GA
1. Screws
2. Steering padding
Remove steering padding no. 23.
Handlebar
Remove steering cover and steering padding as
mentioned above.
Remove 4 elastic stop nuts M8 no. 24 retaining
steering clamp no. 25.
F07K0SA
12
TYPICAL
1. Remove nuts
2. Steering clamp
Detach steering clamp no. 25 and remove handle-
bar no. 9.
On GTX Supercharged Limited models,with-
draw rubber pad no. 26 and stopper no. 27.
F07K0TA
1
2
TYPICAL
1. Rubber pad
2. Stopper
Cable Support
RXP Models
Remove front vent tube.
All Models
Loosen bolts no. 28 and remove retaining block
no. 29 from cable support no. 30.
1
F18K0IA
1. Retaining block
Loosen bolts no. 31 each side of steering support
no. 32.
smr2005-022 231
www.SeaDooManuals.net

Sea-doo 2005 4-Tec models Specifications

General

Displacement	1494 cc
Fuel Type	Unleaded gasoline
Engine Type	4-TEC
Cooling System	Closed-loop cooling
Seating Capacity	3
Width	48 inches (122 cm)
Fuel Capacity	15.9 US gallons