MRD 3187B - User Manual
Page 103 (245)
Setting the CAM Operation Mode
1. Use the and buttons to move
the cursor to “CAM Operation Mode”,
then press the button.
2. Use the and buttons to
change the mode (“Use Decoded
PIDs” or “Use Selected PIDs”), then
press the button to save the
selection.
Note: Depending on the mode selection, the menus below the mode options will
have changed.
Use Decoded PIDs
In the “Use Decoded PIDs” operation mode, the CAM will decrypt the audio and
video programs that are decoded by the MRD 3187B. The Service Selection
tuning determines the program that is sent to the CAM for decrypting before the
decoding takes place. Only the program used for decoding is sent to the CAM no
matter how many programs the CAM is capable of decrypting. If programs other
than ( or in addition to) the one being decoded is to be sent to the CAM for
decryption, the “Use Selected PIDs” mode should be used.
Use Selected PIDs
The “Use Selected PIDs” operation mode allows the selection of individual video
and audio PIDs to send to the CAM for decryption. There is no restriction on
which PIDs can be selected (audio and video PIDs need not be in the same
program). The PIDs are selected from the PIDs that are available in the PMT of
the input. If there is no input PMT available, the selection of PIDs will not be
possible. If a selected PID is no longer listed in the input PMT, the Service that
contained the PID will be listed followed by a “*” indication. The Services with
PIDs that are no longer in the PMT can be found on the bottom of the Service
list.
Once “CAM Operation Mode” has been set to “Use Selected PIDs”, use the
following steps to configure your MRD 3187B to decrypt selected PIDs.
Note: It is only possible to decrypt more than one program at a time, if the CAM
module supports multiple program decrypting.
1. The Services that are sent to the
CAMs are listed under the “CAM1” or
“CAM2” (with the CAM name if
available).
2. Use the and buttons to move
the cursor to the program (Service)
which contains the PIDs to be
selected, then press the button.
3. The video and audio PIDs that are
available for that Service in the PMT
are listed.
CA Systems RDS1
CAM2:NagraVision
► SVC:816 ABCHE
Svc:892 CBCMH
CA Systems RDS1
►CAM2:NagraVision
SVC:816 ABCHE
Svc:892 CBCMH
CA Systems RDS1
►CAM Operation Mode:
Use Decoded PIDs
CAM2:NagraVision
To Next Page
Loading...
