Sencore MRD 3187B - Page 138

MRD 3187B - User Manual
Page 137 (245)
2. Press again and use the and
buttons to select “Enabled” or
“Disabled”, then press the button.
Port Setup
1. Select “Port 1” or “Port 2” and then press
the button.
2. The MAC address is now displayed for the
port that was chosen. The Link status and
Agr Bit Rate is also displayed.
3. Press the button.
IP Address/Subnet Mask/Gateway
1. Use the and buttons to move
the cursor to “IP Address”, then press
the button.
2. Use the and buttons to
select the column to edit and use the
and buttons to change the
IP, then press the button to save
the selection.
3. The cursor will now be on, “Subnet
Mask”.
4. Use the and buttons to
select the column to edit and use the
and buttons to change the
Subnet Mask, then press the
button to save the selection.
5. The cursor will now be on, “Gateway.”
6. Use the and buttons to
select the column to edit and use the
and buttons to change the
Gateway, then press the button
to save the selection.
PID Filtr Port 1←→
255.0.0.0
Gateway
► 000.000.000.000
PID Filtr Port 1←→
10.0.0.51
Subnet Mask
► 255.000.000.000
PID Filtr Port 1←→
IP Address
► 010.000.000.051
Subnet Mask
PID Filtr Port 1
MAC:00:01:2A:BC:D1:23
Link: Down
Agr Bit Rt:39.33Mbps
PID Filter IP Cfg
►Port 1
Port 2
Set Default Gw Port
PID Filter 1-4 IP
► ICMP(ping):Enabled