Sencore MRD 3187B - Page 78

MRD 3187B - User Manual
Page 77 (245)
Source
This option will select which input, on the back of the card, will be active.
1. Use the and buttons to move the
cursor to “Source:” then press the
button.
2. Use the and buttons to select
which input to be active (“A”, “B”), then
press the button to save the
selection.
Input A
These settings correspond to the input on “Source A”.
DVB Mode
The DVB-S/S2 card can receive either DVB-S or DVB-S2 transmission.
1. Use the and buttons to move
the cursor to “DVB Mode:” then press
the button.
2. Use the and buttons to
select either “DVB-S” or “DVB-S2”,
then press the button to save the
selection.
Frequency A
The DVB-S/S2 card tunes by the L-band frequency rather than the transponder
frequency or local oscillator value. The L-band frequency is the difference
between the downlink transponder frequency and the LNB local oscillator
frequency.
1. Use the and buttons to move
the cursor to “Freq:” then press the
button.
2. Use the and buttons to
select the column to edit and use the
and buttons to change the
frequency (950 MHz – 2150 MHz),
then press the button to save the
selection.
Symbol Rate A
1. Use the and buttons to move
the cursor to “Sym Rt:” then press the
button.
2. Use the and buttons to
select the column to edit and use the
and buttons to change the
symbol rate (1 – 30 MSymbols/s).
3. Then press the button to save
the selection.
DVB-S/S2 2-2
DVB Mode:DVB-S2
Freq:1250.0 MHz
► Sym Rt:27.0000 MSps
DVB-S/S2 2-2
DVB Mode:DVB-S2
► Freq:1250.0 MHz
Sym Rt:27.0000 MSps
DVB-S/S2 2-2
Input A
► DVB Mode:DVB-S2
Freq:1250.0 MHz
DVB-S/S2 2-2
►Source:A
Input A
DVB Mode:DVB-S2