EasyManua.ls Logo

Sennheiser CHG 2W - Integrating the Receiver into a Network with DHCP; Integrating the Receiver into a Network Without DHCP Using Auto IP

Sennheiser CHG 2W
183 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SL Rack Receiver DW
61
Integrating the receiver into a network with DHCP
The receiver obtains the IP address from the DHCP server. You can see this
address in the Network Settings menu on the receiver (seeUsing the op-
erating menu of the receiver”).
To add the receiver in the Sennheiser Control Cockpit:
Use the Add Device function in the Sennheiser Control Cockpit and
enter the IP address you saw in the settings menu.
Or:
Activate the mDNS function in the receiver’s Network Settings menu
(factory setting: deactivated).
Restart the receiver.
Once restarted, the receiver is automatically detected in the Sennhe-
iser Control Cockpit.
mDNS = multicast Domain Name System: resolves host names to
IP addresses within small networks that do not include a local name
server. Used for automatic device discovery.
Integrating the receiver into a network without DHCP using Auto IP
If there is no DHCP server in the network and you are working with auto-
matically generated IP addresses, please observe the following informa-
tion.
Set the Mode to Automatic in the receiver’s Network Settings menu.
Ensure that the host PC on which the Sennheiser Control Cockpit ser-
vice is installed is configured so that the IP address is assigned auto-
matically, rather than a static configuration.
After several minutes, all receivers in the network will receive a link-local
address in the range of 169.254.x.x. You can see this address in the Net-
work Settings menu on the receiver (see „Using the operating menu of the
receiver”).
To add the receiver in the Sennheiser Control Cockpit:
Use the Add Device function in the Sennheiser Control Cockpit and
enter the IP address you saw in the settings menu.
Or:
Activate the mDNS function in the receiver’s Network Settings menu
(factory setting: deactivated).
Restart the receiver.
Once restarted, the receiver is automatically detected in the Sennhe-
iser Control Cockpit.
mDNS = multicast Domain Name System: resolves host names to
IP addresses within small networks that do not include a local name
server. Used for automatic device discovery.

Table of Contents

Other manuals for Sennheiser CHG 2W

Related product manuals