SL Rack Receiver DW
68
Attaching the mounting angles
To fasten the mounting angles:
▷ Unscrew and remove the two recessed head screws on each side of the
receiver.
▷ Secure the mounting angles to the sides of the receiver using the pre-
viously removed recessed head screws.
Make sure that the angled ends of the mounting angles point forward.
►
Installing the receiver in a rack
To install the receiver in a rack:
▷ Use the two supplied recessed head screws to secure the blanking
plate from the GA 4 mounting kit to the mounting angle of the receiver
as shown.
Make sure to use the correct side (the one with the round holes) of the
blanking plate to secure it to the mounting angle.
►
▷ Only insert the two small covering caps into the antenna holes if you do
not wish to install the rod antennae at the front of the rack.
▷ Slide the receiver with the attached mounting accessories into a 19"
rack.
To Next Page
Loading...
