SL Rack Receiver DW
70
Installing two receivers next to one another in a
fixed location
This chapter describes how to install two receivers next to one another in
a fixed location, e.g. in a 19" rack.
You can also install just a single receiver in a rack. You can find more infor-
mation about installing a single receiver under: „Installing a single receiver
in a fixed location”.
You can also set up the receiver without installing it in a fixed location. You
can find more information about setting up the receiver under: „Setting up
the receiver”.
ATTENTION
Danger due to high temperature, mechanical loading or electric leak-
age currents
When rack mounted, a receiver can be damaged by excessive heat or me-
chanical stress.
▷ Make sure that the temperature within the rack does not exceed the
permissible temperature limit specified in the specifications.
▷ Make sure that the receivers in the rack are not subject to mechanical
stress.
▷ Make sure that circuits are not overloaded by providing overcurrent
protection if necessary.
▷ Make sure that the sum of the leakage currents of all power supply
units do not exceed the allowable limit values by grounding the rack via
an additional ground connection, if necessary.
To Next Page
Loading...
