SL Rack Receiver DW
63
Setting up the receiver
This sections describes how to set up the receiver.
You can also install the receiver in a fixed location, e.g. in a 19" rack. You
can find more information about installing the receiver in a fixed location
under: „Installing a single receiver in a fixed location”.
Affixing the device feet
Only affix the device feet if you are setting the receiver up in the stand-
alone position instead of installing it in a 19" rack. The device feet will get
in the way if the receiver is installed in a rack.
To affix the device feet:
▷ Clean the recesses for the device feet at the base of the receiver.
▷ Affix the device feet to the recesses of the receiver.
▷ Place the receiver on a flat, horizontal surface.
The device feet will adhere reliably to the receiver only after some time.
Avoid moving the receiver during this time.
ATTENTION
Risk of staining furniture surfaces
The device feet my leave stains if they come into contact with furniture.
▷ Do not place the receiver on delicate surfaces.
To Next Page
Loading...
