Attaching the microphone 136
Connecting the MKE 1 to the SL Bodypack DW 137
The SL DI 4 XLR Dante™ interface 138
Product overview and LED indicators – front panel 139
Product overview and connections – rear panel 140
Powering the SL DI 4 XLR 141
Power supply via Ethernet cable 141
Power supply via the optional Sennheiser NT 12-50CS power supply unit 141
Daisy-chaining the power supply 142
Connecting audio signals 143
Configuring the SL DI 4 XLR using the SL DI CONTROL software 144
Starting the SL DI CONTROL software 144
Selecting the network interface 145
Establishing a connection to a SL DI 4 XLR 146
Changing the settings 147
Saving and loading settings 148
Identifying devices 148
The Dante Debug Mode 149
The CHG 2 charger 151
Product overview 152
Connecting the CHG 2 charger to the power supply system 153
Charging the accupack in the CHG 2 charger 154
The CHG 4N charger 155
Product overview 156
Connecting the CHG 4N charger to the power supply system 157
Charging the accupack in the CHG 4N charger 159
Meaning of the charging slot status LEDs 160
Controlling and monitoring the CHG 4N charger over the network 161
Connecting the CHG 4N charger to the network 161
Integrating the CHG 4N charger into a network with DHCP 162
Integrating the CHG 4N charger into a network without DHCP using Auto IP
162
Integrating the CHG 4N charger into a network without DHCP using Fixed
IP 162
Connecting a pre-configured CHG 4N charger to the Sennheiser Control
Cockpit 163
Resetting the CHG 4N charger’s network settings 163
Updating the firmware 164
The CHG 2W charging base 165
Product overview 166
Connecting the CHG 2W charging base to the power supply system 167
Charging a device using the CHG 2W charging base 168
Meaning of the status LEDs on the charging surfaces 169
To Next Page
Loading...
