CDHD Specificat ions
User Manual 23
Single an d Th ree-
Ph a se 1 2 0/ 2 4 0 VAC
Spe cifica t ion CD H D - 4 D5 CD H D - 0 0 6
Mot or Output ( U, V, W) Continuous Out put Current (A rms) 4.5 6
Continuous Output Current (A peak) 6.63 8.48
Peak Output Current (A rms) for 2 seconds 18 18
Peak Output Current (A peak) for 2 seconds 25.45 25.45
kVA at 120 VAC 0.5 0.7
kVA at 240 VAC 1.1 1.5
PWM Frequency (kHz) 16 16
Soft Start Max. Surge Soft Start Current (A) 7 7
Max. Charge Time (ms) 250 250
Power Circuit Loss W
Control Circuit Loss W 5 5
Total Power Loss W
H ar d w a r e
Unit Weight kg 0.97 0.97
Connection Hardware PE Ground Screw Size/ Torque M4/ 1.35 Nm M4/ 1.35 Nm
Wire Size Control Circuit ( AWG) up to 3 met ers 24-28 24-28
Main Circuit Motor Lines ( AWG) 16 16
Main Circuit AC Inputs (AWG) 16 16
PE Ground Screw M4 M4
Clearance Dist ance Side- to- Side (m m ) 15 15
Top/ Bottom (m m ) 50 50
Volt a g e Trip
Under-Volt age Trip (Nom inal) (VDC) 100 100
Over-Voltage Trip (VDC) 420 420
Pow e r Te m pe r a t u r e
Fan
Norm ally operates at quart er power; when
temperature exceeds high- speed fan trigger
tem perature, operat es at full power
Yes Yes
Power Module Over-Temperature Fault Regulated (° C) 80 ± 5% 80 ± 5%
Power Module Over-Temperature Fault Non-regulated
(° C)
100 ± 5% 100 ± 5%
Trigger Tem perature for High Speed Fan (° C) 45 45
Ex t e rnal Regene ra t ive
Resist or ( B1 + , B2 )
External regenerative
resistor requirement
(regen resist or not
supplied with drive)
Peak current ( A) 25.5 25.5
Minimum resistance (Ω) 16 16
Power Rating (W)
Syst em -
dependent
Syst em -
dependent
Application Inform ation Internal Bus Capacitance (µF) 1120 1120
VLOW (Regen Circuit Turn Off) (VDC) 380 380
VMAX (Regen Circuit Turn On) (VDC) 400 400
* Line to Line: L1 to L2, or L1 to L3 or L2 to L3
To Next Page
Loading...
