4. Basic Operation
4-10
CBM-20A/20Alite
4.2 Creating Method Files
Parameters for all the components are set and saved as method files. To start analysis,
retrieve an appropriate method file to be used as a basis for the analysis procedure.
Method files can be created in either the "Analysis" tab page or the "Editing" tab page of the
"Analysis Execution" application. Although the creation method is the same for both pages,
the functions of the pages differ in the following way.
• The method file displayed in the "Analysis" tab page is the file that is currently used. The
method-file contents configure on this page are applied directly to all the components.
• In the "Editing" tab page, method files that are not currently being used can be selected and
edited.
This section describes the method for creating a new method file from the "Analysis" tab page
below.
Configuration parameters are not included in method parameters.
Among the autosampler's method parameters, the parameters that depend on the
sample rack are common to all method files. If these parameters are changed in one
method file, these changes are applied to all other files (No. 0 to 19).
"5.12.2 Autosampler" P. 5-74
4.2.1 Selecting Method Files
In order to create a new method file, it is first necessary to select a method file and load it.
1
Click the [Analysis] tab in the "Analysis Execution" application window.
The "Analysis" tab page is displayed.
To Next Page
Loading...
Need help?
General
