Shimadzu CBM-20A - Analysis Using Fraction Collectors; Parameters for the Fraction Collector; Selecting Method Files

5.6 Analysis Using Fraction Collectors
5-21
CBM-20A/20Alite
5
5.6 Analysis Using Fraction Collectors
Using a fraction collector makes it possible to automatically measure out (fractionate) eluate
from the column according to the detector signals. To use a fraction collector, enter the
fraction collector parameters in the method file. A time program controls the fraction collector
in the same way as other components. If a rack other than a Shimadzu rack is used, teaching
of the custom rack must be performed for the fraction collector.
5.6.1 Selecting Method Files
Select a method file that uses the fraction collector.
The method file can be selected from either the "Analysis" tab page or the "Editing" tab page
in the "Analysis Execution" application.
The selection method is the same for both pages.
"4.2.1 Selecting Method Files" P. 4-10
5.6.2 Parameters for the Fraction Collector
Set the parameters for the fraction collector, such as the slope and the level.
The method for setting the parameters from the "Analysis" tab page is described below.
1
Click in the "Analysis" tab page.
The "Fraction Collector" tab page in the "Method Parameter" window is displayed.