Shimadzu CBM-20A - System Controller Installation and Setup (Example)

9. Technical Information
9-32
CBM-20A/20Alite
9.4 System Controller Installation and
Setup (Example)
At system installation or the change of an installation location, it is necessary to set or change
the component information and network settings. This allows control of the system controller
from a PC over the network or sharing of component information between system controllers.
The following example describes how to set group names and IP addresses.
9.4.1 System Configuration (Example)
The following example describes connecting this type of LC system to the network.
Fig. 9.18
Group 1
Group 2 Group N
Group 1