Shimadzu CBM-20A - Page 201

5.12 Parameter Details
5-73
CBM-20A/20Alite
5
 LC-10ADvp, LC-10AD, LC-10ATvp, LC-10AT, LC-10Ai, LC-10AS, LC-8A, LC-7A, LC-6AD
1. Pumping stops when the error is cleared.
2. This setting can be made for each solvent delivery module. Set the valve type at each solvent delivery module
beforehand.
3. Select [Used] if a solenoid valve is connected.
Parameter Setting range Default setting Remark
System Protection
Disable
Enable
Disable
Disable: Stops pumping.
Enable: Continues pumping at half the flow rate. (See
note 1.)
Pressure units
MPa
kgf/cm
2
psi
bar
MPa
Solenoid Valve
Not Used
Used
Not Used
Not Used: The solenoid-valve parameter is not
displayed in the "Pump" tab page in the "Method
Parameter" window.
Used: The solenoid-valve parameter is displayed in the
"Pump" tab page in the "Method Parameter" window.
(See notes 2 and 3.)