Shimadzu CBM-20A - Page 60

2. Parts Identification and Function
2-20
CBM-20A/20Alite
Run Run Analysis is being executed.
Transmit Run
Analysis sequence data is being transmitted to the
autosampler.
Pretreat Run The autosampler is performing pretreatment.
Posttreat Not Ready
The autosampler is running after the analysis is
completed.
Pause Run
Analysis has been temporarily stopped by clicking .
WaitSeq Run The analysis queue is in waiting status.
CoolingDown Run The system is shutting down.
WaitDP Run The data processor is in waiting status.
ChangingRack Run The changer is changing racks.
Stop Not Ready
The autosampler has stopped operation because
was clicked or an error occurred. Resume operation by
clicking .
SILDoorOpen Not Ready The autosampler's door is open.
SafetyLock Not Ready
The autosampler is not operating and the safety lock is
activated.
Rinse Not Ready The autosampler's needle is being rinsed.
SILPurge Not Ready Autopurge is being performed for the autosampler.
Z.Home Not Ready The autosampler's needle is at the home position.
A.Purge/B.Purge/
C.Purge/D.Purge
Not Ready
Autopurge is being performed for the solvent delivery
module.
InitConcFlow Not Ready
The mobile phase is being replaced at the method's initial
concentration after execution of autopurge for the solvent
delivery module.
WaitCTO
Run or Not
Ready
The system is waiting for temperature control of the
column oven to stabilize.
CTODoorOpen Not Ready The column oven door is open.
StackOpen Not Ready The rack changer stack is open.
InitializingChanger Not Ready The rack changer is initializing.
WaitSIL Not Ready The autosampler is not ready.
DetectingRack Not Ready The changer is performing rack detection.
"Sequence" section
display
"Status" tab
page display
Description