Safety Instructions
VII
CBM-20A/20Alite
Installation Precautions
To ensure safe operation, contact your Shimadzu representative if product installation, adjustment, or re-
installation (after the product is moved) is required.
CAUTION
• Avoid installation sites that are exposed to corrosive
gases or excessive dust.
These adverse conditions may be detrimental to maintaining the
instrument performance and may shorten its service life.
WARNING
• Take measures to prevent the instrument from falling
in the event of an earthquake or other disaster.
Strong vibrations could cause the instrument to fall over,
resulting in injury.
• The power supply voltages and power consumptions
of this instrument are listed below. The power supply
voltage of the instrument is indicated on the label on
the back of the instrument. Connect the instrument to
a power supply that complies with the capacity and
use a power cord that complies with the capacity;
otherwise, fire or electric shock could result. Check that the
power supply voltage is stable and that its current capacity is
sufficient to operate all the components of the system. If not, the
instrument will not operate at its rated performance.
CBM-20A
1: 100 VA, if AC OUT is not used.
2: Connect the instrument to a power outlet that is equipped with a circuit breaker that shuts off the current at the
described value or less.
Part No.
Power Supply Voltage
(indicated on the instrument)
Power
Consumption
Frequency
Rated Breaking
Capacity
2
S228-45012-31
/41
AC 100-120 V (100-120 V
)
400 VA
1
50-60 Hz 40A
S228-45012-32
/42
AC 100-120 V (100-120 V
)
400 VA
1
50-60 Hz 40A
S228-45012-38
/46/48/58
AC 220-240 V (220-240V
)
400 VA
1
50-60 Hz 40A
To Next Page
Loading...
