SICK DUSTHUNTER T100

110
8012428/YWL2/3-0/2016-08| SICKO P E R A T I N G I N S T R U C T I O N S | DUSTHUNTER T
Subject to change without notice
6 TROUBLESHOOTING
6.3.3 Replacing the fuse
▸ Control unit MCU must be disconnected from the power supply and potential-free.
▸ Open the door of the MCU, remove and open fuse holder (1).
▸ Replace the defective fuse (2) (see “Miscellaneous”, page 125).
▸ Close and attach the fuse holder.
▸ Close the door and connect power voltage.
Fig. 77: Replacing the fuse



Fuse holder

Fuse