SICK DUSTHUNTER T100

111
8012428/YWL2/3-0/2016-08| SICK O P E R A T I N G I N S T R U C T I O N S | DUSTHUNTER T
Subject to change without notice
SPECIFICATIONS 7
7Specifications
7.1 Compliances
The technical design of this device complies with the following EU directives and EN
standards:
● EU Directive: LVD (Low Voltage Directive)
● EU Directive: EMC (Electromagnetic Compatibility)
Applied EN standards:
● EN 61010-1, Safety requirements for electrical equipment for measurement, control
and laboratory use
● EN 61326, Electrical equipment for measurement technology, control technology and
laboratory use - EMC requirements
● EN 14181, Stationary source emissions - Quality assurance of automated measuring
systems
Electrical protection
● Insulation: Protection class 1 according to EN 61010-1.
● Insulation coordination: Measuring category II according to EN 61010-1.
● Contamination: The device operates safely in an environment up to degree of contami-
nation 2 according to EN 61010-1 (usual, not conductive contamination and temporary
conductivity by occasional moisture condensation).
● Electrical energy: The wiring system to the power supply voltage of the system must be
installed and fused according to the relevant regulations.
Approvals
The DUSTHUNTER T100 and DUSTHUNTER T200 variants are performance-tested in accor-
dance with EN 15267 and may be used for continuous emission monitoring in plants
requiring approval and plants according to the EU Directives.