SICK DUSTHUNTER T100

87
8012428/YWL2/3-0/2016-08| SICK O P E R A T I N G I N S T R U C T I O N S | DUSTHUNTER T
Subject to change without notice
START-UP AND PARAMETER SETTINGS 4
4.6.3 Menu structure
Fig. 59: LC-Display menu structure
4.6.4 Configuration
4.6.4.1 MCU
Analog outputs / inputs
▸ Set the MCU to “Maintenance” mode and select the “I/O Parameter” submenu.
▸ Select the desired parameter and enter the default password “1234” using the “^”
(scrolls from 0 to 9) and/or “→” (moves the cursor to the right) buttons.
▸ Select the desired value using the “^” and/or “→” buttons and write it to the device with
“Save” (confirm 2x).
1): as in the operating state
2): see “MCU”, page 87
3): see “Sender/receiver unit”,
page 90
1)
2)
}
1)
}
3)