SICK S300 Mini

11. Tighten the screws using the set tightening torque.
12.
Make sure that the optics cover is clear of dirt and damage.
Recommissioning the safety laser scanner:
b
Correctly re-mount the safety laser scanner.
b
Connect the round plug connector at the end of the connecting cable of the safety
laser scanner.
b
Now perform an optics cover calibration using the CDS.
Further topics
•
"Accessories", page 123
•
"Additional accessories", page 126
•
"Mounting", page 58
9 M
AINTENANCE
100
O P E R A T I N G I N S T R U C T I O N S | S300 Mini 8014170/ZA23/2019-11-14 | SICK
Subject to change without notice