SICK S300 Mini User Manual

You can use this function, for example, if you use several vehicles and they do not move
f
or a time.
Further topics
•
"Round plug connector of the S300 Mini Standard", page 66
•
"External device monitoring (EDM)", page 75
•
"Restart", page 76
7.10 Field Sets
The number of field sets that can be configured depends on the safety laser scanner
v
ariant. The following table shows the number of field sets per variant:
Table 17: Number of field sets that can be configured per variant
Standard Remote
Number of field sets 1 16
7.10.1 Configuring the protective field and warning field
The field set, which comprises a protective field 1 and t
wo warning fields 2 is config‐
ured using the CDS. This involves configuring the shape and size of the protective field
and warning field. Any field shape can be created.
The area to be monitored is scanned radially by the device. The device cannot see
through objects, however. The surface behind objects which are located in the area to
be monitored (support columns, separator grids, etc.) can therefore not be monitored.
Figure 59: Creating a field set in the CDS
Pr
otective fields and warning fields can cover an angle of up to 270° and have different
radial scanning ranges depending on the variant and the resolution configured.
WARNING
P
ersons or parts of the body to be protected may not be recognized or not recognized in
time in case of non-observance.
Before commissioning the machine or vehicle, check the configuration of the protective
fields, see "Commissioning", page 93, see "Checklist for initial commissioning and
commissioning", page 133.
b
Check the configured protective fields.
7 C
ONFIGURATION
80
O P E R A T I N G I N S T R U C T I O N S | S300 Mini 8014170/ZA23/2019-11-14 | SICK
Subject to change without notice

SICK S300 Mini Specifications

General

Brand	SICK
Model	S300 Mini
Category	Scanner
Language	English