Siemens FUS1010 - Page 118

Functions
7.5 Analog Out Setup
FUS1010 IP65 NEMA 4X & IP66 NEMA 7
Operating Instructions, 01/2013, A5E02951520-AC
117
$QDORJ2XW6HWXS
6LHPHQV 'XDO3DWK>@3DWK
$VVLJQ'DWDWRWKHWRP$RXWSXW
,R   69IR
,R
  69IDE
9R   69V
9R   69DOF
3JHQ 69DHU
3JHQ   9IR
9IDE
9V
9DOF
9DHU
9IR
5. To store selection press <ENTER>.
Vo Output Functions
The Vo analog output is a 0-10 VDC signal that varies linearly in relation to a selected
function.
Assigning a function to the voltage output:
1. From the [Analog Out Setup] menu, press <Right Arrow] to access the [Vo1] option list.
2. Move the cursor to the desired data function by pressing <Up/Down Arrow>.
3. To store selection press <ENTER>.
Pgen Output Functions
The Pgen analog output is a buffered TTL-compliant pulse rate signal that varies linearly
from 0-5000 Hz in relation to a selected data function.
Assigning a function to the Pgen output:
1. From the [Analog Out Setup] menu, press <Right Arrow> to access the [Pgen] option list.
2. Move the cursor to the desired data function by pressing <Up/Down Arrow>.
3. To store selection press <ENTER>.